Quick Start (Continued)

View

1. To view the appropriate program parameters, push the

parameter control knob to move the arrow to the left of

the program number.

2. Select the appropriate program number by rotating the

parameter control knob, then hold the knob in, releasing

after a new screen is displayed.

3. The new screen will outline the parameters currently

stored under that program number. Push the parameter

control knob again to return to the setup screen.

Load

1. To load a saved program, push the parameter control

knob to move the arrow to the left of the program

number. Please note that in addition to three available

programs, there is also the default program as outlined

in the “Initializing” section.

2. Rotate the knob to change the program number.

3. Push and hold the knob in, releasing after a new screen

is displayed. The new screen will read “Loaded Set N to

Current Parameters”.

4. Push the parameter control knob again to return to the

setup screen.

On-Line Help

In the Set Parameter Mode, an On-Line Help function is enabled.

On-Line Help provides a definition for all set parameters and

advanced functions.

1. To use On-Line Help, rotate the parameter control knob

so that the arrow is to the left of the parameter or feature

of interest (not the value of the parameter).

2. Push the parameter control knob in and hold until the

definition is displayed.

3. Push a second time to return to the Set Parameter Screen.

Mode     Low voltage or high voltage range mode

Voltage  The amplitude of the output pulse

P Length The time duration or length of the pulse