Chemical resistance: resistant to oils, alcohols, ketones,

chlorinated hydrocarbons, dilute acids, esters and aromatic

hydrocarbons, gasohol.

*Coating cured at 160°C for 60 minutes; substrate: zinc

phosphated steel; coating thickness: 0.025 mm.

DIRECTION OF USE

Preliminary Statement

Prior to use it is necessary to read the Material Safety Data

Sheet for information about precautionary measures and

safety recommendations. Also, for chemical products exempt

from compulsory labeling, the relevant precautions should

always be observed. Please also refer to the local safety

instructions and contact Henkel for analytical support.

Pretreatment

Substrates should be clean and dry before application. A

solvent wipe and air dry is usually sufficient. For critical

applications requiring maximum adhesion, mechanical or

chemical pretreatment such as grit blasting, phosphating,

anodising or etching is recommended. Specific

recommendations will be provided upon request.

Mixing

BONDERITE S-FN 330 ACHESON can be spray applied

undiluted. However, to obtain maximum smoothness, dilute

the product with methyl ethyl ketone (MEK) in the ratio of

three parts product (by weight) to one part solvent.

Application

Use an external-atomizing spray gun with 2 to 3 bar air

pressure and adjust the gun to give a well-atomized spray.

For optimum performance, the final coating thickness should

be 10 to 25 μm.

For thicker coatings use multiple passes pausing a few

minutes between passes to permit air drying.

When properly applied, the coating will be even and free of

runs, blisters or "fish eyes".

Electrostatic spray equipment suitable for products with very

low internal resistance may be used to apply BONDERITE

S-FN 330 ACHESON.