Edge sealing minimizes the adverse effects of rigorous use or prolonged or severe exposure

conditions by providing water and contaminant-tight seal between a graphic film and

substrate. It is required for some 3M warranted graphics (refer to the base film's Product

Bulletin for details). These products also may be applied even after the applied film shows

signs of wear, such as edge lifting, to significantly reduce further wear; however, such

application does not meet the requirements for warranted graphics.

Edge sealers 3950 and 4150S are single component colorless liquids.

Edge sealer 8914 is a clear tape used to seal vehicle window graphics and for sealing cut

edges and seams on watercraft graphics.

Recommended Types of

Graphics and End Uses

Refer to the base film or flexible substrate's Product Bulletin for details on specific

constructions and any warranty that may apply when using this product.

Limitations of End Uses The solvent in the edge sealer may attack certain painted surfaces; always test in an

inconspicuous area before using.

Characteristics These are typical values for unprocessed product; processing may change the values.

Contact your 3M representative for a custom specification.

Characteristic Value

Color 3950: Clear liquid

4150S: Clear liquid

8914: Optically clear film

Material 3950: Acrylic/vinyl solution in xylene

4150S: Acrylic solution in xylene

8914: Vinyl film

Minimum viscosity 3950: 300 Centipoise

4150S: 700 Centipoise

Percent solids 3950: 46 +/- 2.5 %

4150S: 38+/- 2 %

8914 only Thickness: 2-3.5 mils (0.05 to 0.09) mm

Adhesive: Pressure-sensitive

Liner: Paper

Chemical resistance ? Resists mild acids, mild alkalis, and salts.

? Excellent water resistance.

? Hydraulic fluid, LD-4, will dissolve 3950 within one hour of

exposure.

Application

temperature

50° to 100°F (10° to 38°C)

Service temperature

range of product in use

-60° to +150°F (-51° to + 65°C)