匯分FSQ-YW-001固態顆粒物（香煙煙霧）發生器

1.結構特征

如圖所示，發生器由機箱、燃燒腔視窗機構、氣泵、流量計、開關按鈕、點煙器、循環氣泵及過濾器、CPU板及電源板等幾大部件組成。機箱采用薄不銹鋼板折彎、拼裝焊接而成，表面除銹處理后作白色烤漆。

2.  工作原理 

本發生器采用正壓空氣吹入法發生煙霧，將香煙固定于底座煙嘴上，燃燒腔管接于底座，用點煙器點燃香煙，同時開始計時，香煙在（40～50）s 內燃燒完畢，固態顆粒物（香煙煙霧）經煙嘴尾部的煙霧導出管導入到測試艙內。香煙燃盡后，關閉進氣泵并關煙灰斷煙霧輸出，進入循環氣泵工作狀態，將原來燃燒腔視窗內殘留的煙霧過濾干凈。

Huifen FSQ-YW-001 Smoking Generator 

Structural features

As shown in the figure, the generator consists of several major components, such as chassis, combustion chamber window mechanism, air pump, flowmeter, switch button, cigarette lighter, circulating pump and filter, CPU board and power board. The chassis ,made by thin stainless steel , was producted by bending, assembled and welded process. The surface ,baked with white paint  had been deal with  derustiing processing.

2 working method

The generator adopts a positive pressure air blowing method to generate smoke. The cigarette is fixed on the cigarette holder which is connected to the the combustion tube. The cigarette is ignited by the cigarette lighter. At the same time ,the time counting starts. The cigarette will burn up within (40-50) s .The solid particulate matter (cigarette smoke) is introduced into the test chamber through the smoke outlet tube at the tail of the mouthpiece. After the cigarette burns out, the machine will close the intake pump and shut off the smoke output. Then it will start the  circulating gas pump and filter the residual smoke in the Combustion chamber.

Solid particles (cigarette smoke) generator cent points FSQ-YW-001

Technique parameter

Generator flow range  1-5L / min

Generating frequency  40 ~ 50/Sec.

Power                 AC, 220V / 50Hz

Maximum power consumption

Weight                7kg

Dimensions            360×270×400H mm